Alientech Kess V3 ECU Programmer released a new upgrade on April 10th, 2024. Thanks to this new development for KESS3, you can remap via OBD the Bosch MSE8.0 engine control unit installed on CF Moto’s CForce range models and Zontes’ small-displacement ZT models. New ECU: Bosch M Continue Reading →
As a beginner, it’s important to start with simple modifications and work your way up. Make small changes to your ECU settings and see how they affect your engine’s performance. As you become more experienced, you can gradually increase the complexity of your modifications. Here is re Continue Reading →
Here are some best ECU programmers for beginner. It is advisable to use the original tool to ensure non-infringement, quality assurance, and tech support. Alientech KESS V3, CG FC200, OBDSTAR DC706, Launch X431 ECU & TCU Programmer, Launch X431 X-Prog3 PC Adapter, Xhorse Multi-Prog Continue Reading →
Alientech Kess V3 ECU Programmer released the newest software V1.92 on March 27th, 2024. It added Keihin 6001-19PE-002/ RH850, Continental Siemens VDO M3C S12X256SV/ S12XET256MAL ECUs reading and writing functions in Bench/Boot modes for Triumph, KTM and Ducati brands motorcycles. Update d Continue Reading →
CG FC200 ECU Programmer released the newest software V1.1.9.0 in March 2024. The BOSCH ST10 ECU and checksum function were added, as well as support for Denso ECU and other brand ECUs. A new button for “DTC off support list” was also added to the main interface, along with some bug f Continue Reading →
Alientech Kess V3 ECU Programmer newly released a software upgrade on Japanese vehicles with Denso ECU on March 20, 2024. Update Info: Thanks to eight new protocols available on KESS3, you can work on bench/Boot on Denso engine control units 112731-5040, Denso 112800-3288, Denso 275236-0011, Den Continue Reading →
How about OBDSTAR DC706 ECU Tool? Compared with IO Terminal, any good? DC706 has full clone function. It supports ECM, TCM and Body/other system clone via OBD or Bench. It can read ECU info, R/W Eeprom/Dflash/Pflash/MAP, reset ECU (Virgin), calibrate mileage, read IMMO pincode, and recover ECU&# Continue Reading →
Alientech Kess V3 ECU Programmer released the newest software V1.90 on March 13th, 2024. It added Mitsubishi 21175-1124/1125 motorbikes read/write on bench, and Denso 32910-10LXX, etc ECUs in Boot mode. Update details: Bench remaps on several Benelli, CF Moto, Honda, Kawasaki, Suzuki and Ya Continue Reading →
Foxflash ECU Programmer Customer Problem: I can’t read id and flash? Renault Trafic 1.6 Bosch EDC17C42 Tried via obd and also via bench mode, always same? Have this message: ERROR !!! contact support info@dfb-technology.com. Eobdtool.co.uk engineer replied: It cannot read via obd if th Continue Reading →
